Originally Posted by
Steven Ruttenberg
I made some adjustments, but I had to use the built in Tmax100 profile and set the CI to .8 to get 3.05 from scanner. Yes, it was set to 16bitin and 16 bit out. But, it seems bettet scanning as 48bitrgb and output 48bit rgb. I was referring to line pairs per mm and using a rough estimate I remember from some reading I did a while ago. If it is 200 line pairs per mm, that is incredible. Once I get my hi res target, I can see exactly what scanner is capable of. So far, it seems a bit easier at least to use the scanner profile for tmax than to adjust manually, the downside is you don't get a linear output I think. But I will check this out I as I continue to learn this scanner which does seem quite amazing for 1000 bucks.
Bookmarks