Jac, My base is just like yours. 3 pieces with top baseboard.
But the bottom sub base was shortened as deduced from welds.
Putting the base board height about 20".
These can fit in 8' ceilings if a modern LED head it used.
Jac, My base is just like yours. 3 pieces with top baseboard.
But the bottom sub base was shortened as deduced from welds.
Putting the base board height about 20".
These can fit in 8' ceilings if a modern LED head it used.
Tin Can
One more picture of the underside of the frame. A marvelous thing about this Saltzman is that all the parts (shafts, tubes, universal knuckles, gears, chain and fasteners) are American standard so replacing parts required only a two-mile drive to our farming supply store.
Remember - a fastener over-tightened is already half broken.
I finally figured out what this part is (that came with a random pile of parts from my newly acquired Durst 184). It's a glassless negative carrier!
Have any of you seen something like this? Who made it? I will have to fabricate a carrier for it so that I can insert it into my Durst Laraneg or Condit 10 x 10 negative carriers.
I don't know, but it sure looks factory made
I believe at one time all major enlarger producers made a glassless carrier for larger sheet film
However some here really don't like them...
I like them!
Tin Can
Just slightly...menacing. Better watch those appendages!
Bookmarks