Hi Printers,
Two boxes have arrived. One has bending damage to the box middle, the box ends were not crushed. A few prints are slightly crimped in the middle, but not all are. It is minimal on left center edge for 1". Maybe fixable with a hot press. I will not do that as I don't want that responsibility.
I suggest anyone that has not yet shipped include something to strengthen the box.
I have used old mat board, thin plywood, foamcore, etc. The box is same cost for any weight I think to over 20 lbs lbs, so steel plate could be used. NOT suggested as that amount of sharp edged mass will rip the box open. I had that happen with a lens shipment last month. Heavy lens...the outer box was wide open. All good.
Hendrik has stated here that his box is coming from EU and I know US customs is working as I had a China shipment pass Chicago customs this weekend.
The Print Exchange is ON!
Bookmarks