Other than Tray processing, how do most of you process 11x14 film? I process sheet film from 4x5 o 8x10 in 1 gal stainless tanks, but don't have tanks or hangers for 11x14. Suggestions appreciated. Thanks, Luis
Other than Tray processing, how do most of you process 11x14 film? I process sheet film from 4x5 o 8x10 in 1 gal stainless tanks, but don't have tanks or hangers for 11x14. Suggestions appreciated. Thanks, Luis
I use a 11x14 print drum and a Unicolor roller to develop one sheet of 11x14 film.
some jobo tank (it came w/o the big long tube in the middle - and I wrecked about 4 sheets before I figured out - THERE IS A HOLE where light can enter the tank... and put a rubber stopper in it) and a Beseler motor roller base
The lids on Jobo tanks/drums come with either a light trap when used with center column (big long tube) or a cup when used as a print drum. If you wish to use a drum for sheet film it is best to use a lid with a cup, the light trap and cup are interchangeable as they just twist off.
I use a jobo tank for this.
Jobo 3062/3063. Yes, unfortunately they've become very expensive.
@Oren:
Can you tell me how you do it? Two sheets in the 3062? I've had great success with a 2000 series Jobo setup doing 11x14 and 14x17 one sheet at a time but when doing 2 sheets of 11x14 in the 3062 the result isn't always the best - especially with Pyro developers that get all sorts of nasty lines from the ribs in the tank. Rodinal seems to be better for sure. I'm experimenting a bit with creating inserts that protect the film from the ribs.
Best, Angus
Afraid I don't have a fix for you. But I'm glad you brought this up because it's a necessary clarification. I've used the 3062 and 3063 successfully only with standard developers like D-76 - I've never used a pyro developer. But others who have tried with pyro developers have reported the same sort of trouble that you've seen with marks from the ribs.
Bookmarks