Hoping for some tips on how to get around a problem. I'm using a heat press to flatten fibre prints - there are sixty of them, 16x20 inches, Ilford MGWT. The prints were air dried and are reasonably curly so we want to flatten them. Using correct procedure with the heat press, most of them are coming out fine. However there are about fifteen prints that are quite wavy along the short edges. When we put these through the press they came out with obvious cracks along those edges. We stopped after this happened to two prints, but now have the dilemma of how to proceed. The only thing I can think of is to rewash the prints until hopefully they lose the wave, then dry them and hope they end up in a state that enables them to go through the press OK. I'm just wondering if anyone else has encountered this scenario and if there are any known solutions. Thanks.