Finally decided to purchase a good UV light box for my alternative process work. Was about to purchase a EEP unit with built-in vacuum frame, but LED UV units seem to be the current state of the technology. All I found out there were DIY units. Did find a very low cost ($150) Chauvet DJ LED Shadow DMX UV Blacklight Panel Wash on EBay but I can't believe that it would be powerful enough... it seems too good to be true.
But then yesterday came across the STARLIGHT 2331 TABLE-TOP Nuarc LED Exposure Syst., definitely current LED UV technology. It can expose frames up to 31" x 40" or multiple prints in my case. Goes for bit over 4K.. ouch... This STARLIGHT UV unit is going for twice my budget, but in perspective equal to what I paid for my 11x14 Chamonix. Info at:
http://www.mrprint.com/en/ProductOverview.aspx?id=169
Anybody out there had any experience with this or similar units?
I have been looking around locally for a used UV light box from a printer but no luck.
I'd gratefully welcome for any comments.
Bookmarks