As the camera was made in the USA, the design dimensions would be imperial units (inches, not metric), I will use those to describe it.
Overall measurement is about 14" (about 36cm), although the accuracy of that dimension is not critical. The location of the screws that tighten them onto the tripod block look to be 2-1/2" (62mm?), and as you need it to match the slots from your tripod block you could measure it from them. In its thickest part they seem to be 5/8" thick and taper toward the end. The width is just under 1" (24mm).
I have included a 6" scale in the picture for reference:
Attachment 156731 Attachment 156732 Attachment 156733
Hope that helps,
Len
Bookmarks