Hello, I am new to the forum and have a question regarding the wide angle focusing device and the appropriate lens board. I have read most of the information out there and have a problem with the lens board fitting flush to the focusing device. I ordered the exact lens board # which is a 2X3 linhof tech. The lens board was a special order and not cheap. It seems to be the right outside dimensions however, there is a round flange which should fit inside the focusing device hole, but it is slightly too large and will not fit flush. Therefore it is pretty much useless as is. It was for copal #0 to be used with a 65mm that I really wanted to use.
Does anyone have experience with these devices and is there any solution to this flange flange issue? Appreciate any help, Thanks
Bookmarks