HELP Need it for ILFORD MULTIGRADE 500 HEAD MOUNT SET ADAPTER FOR BESELER 45MXT

[Aschillaci]

I have an Ilford Multigrade 500 that I just mounted on a Beseler 45mxt.
Does anybody know if there is a head mount set for the 45mxt? I found one for the 23c, but I don't if it will fit.
Right now, I have it resting on the bellows and it has an opening gap.
Anybody has this setup?






Thank you!

[Ginette]

No the 23C plate will not fit. A plate exist for the Beseler45. Similar to the left plate on your picture but a very simple flat plate with the opening that will let pass the bottom part of the Ilford 4x5 white diffusion box.
You remove the 2 latches on your Beseler top and the plate screw into the holes of the latches. Then the Head is screw from under the plate.
You need also the long boxes for the Beseler45, the boxes goes below where the condenser was sitting. The small bumbers on the boxes are located at 35mm from the bottom.
I will look, I might have an extra plate. I have also extra boxes for the Beseler.

[Aschillaci]

Thank you Ginette
Please PM me

[Aschillaci]

Problem solved.
Thanks.