I received a CP-31 today that looks like it might need some TLC.
Am hoping to get some hints here on where to begin.
I've read don't operate without water or chemistry. I'm planning to test the processor first by putting 2L water in each bath and then turning it on, testing the temp, transport, etc.
Is there some checklist I should follow? E.g. pumps, rollers / transport, temperature, etc.? It's a little dirty, any cleaning recommendations?
Here's my observation / inspection so far:
1) On the WD module, the top rail, that the roller units rest on, is missing a screw (closest to entry of unit) - the screw hole may also be damaged. I imagine on the WD unit, this will likely cause a problem as if I recall correctly, there is only one other screw holding the rail place.
I notice on the processor the bottom rail is also missing a screw, closest to bath 3, at the exit of unit.
2) On the WD module, the plastic tube with the rubber L in the bath well, which connects to the sprayer rod, is broken off from the bath. How should I try to repair? It's broken right at the base.
3) I have a 3-pin DIN like cable, I think to connect the WD module to the processor, but I can't see where to plug either end.
4) There's a rubber hose with a metal cuff - off the paper exit end of the processor, seems to come out of the gear shaft, what is it?
5) On the processor unit, the paper guide is missing a screw on one side, I seem to have the 6-sided bolt for it (it matches the one on the other side), but not the screw. Wondering if this bolt is also used elsewhere, in case it may go somewhere else.
6) The WD module has 3 tubes, the processor seems to have 3 plugged-tip drain tubes in front, and 6 tubes in back, 3 clear and thin with plugs (seem to have some chemistry inside), and 3 bigger and black, no plugs. Any info on the purpose of these tubes?
7) On the WD module, the gear shaft was unseated from the metal guide holes, e.g. the white plastic inserts on the rod, had come out of the guide holes.
I was able to reseat it, but the washer/rivet thing that seems to hold it in place is loose, not sure how to secure.
Appreciate any guidance.
Thanks,
Bill
Bookmarks