Search:

There were loud noises when I turned on the scanner again after having pulled it out of storage. I had to reset the steel bars that guide the sensor/lens unit. Will report back after I try Bryan's...

Thank you! Will try that later today.

Thanks, I'll try to find out who he/she was. There are many messages :)

Thanks for that. Did not having a central rubber foot or the flimsy table affect the quality of your scans and produce the same issues visible in the cropped section I uploaded the other day?

Hi Peter, thank you very much for your comment. You might be right about the linear motion system. I had to open the scanner and put one of the two steel bars back into place. It had slipped out from...

Hi everyone.

I recently scanned a color neg (as positive) and got some nasty artifacts (see attached image). Just wondering if any of you has seen this sort of stuff before. Scanned at 5300 dpi,...

Thank you very much Christian!

Hi Christian,

I read a few of your posts and I would be grateful to read more about your workflow for scanning negs on the Cezanne.

I tried to get raw data from the scanner, but it doesn't look...