This has to be possible... Linhof boards come drilled for #3 shutters. A #4 Dialset Ilex Shutter is just a tiny bit bigger. So I'm sure it will fit.
From what I am reading I come up with the following sizes for holes in the lens board.
#3, 2.524"
#4 Dialset, 2.604"
Are these numbers right?
Where can I find or have a blank Linhof drilled to that specific size?
When drilling, how accurate do they have to be?
The shutter is a Dialset Ilex Shutter.
What size hole is easily found or can a machine shop drill?
I'm sure I can find a machine shop to drill it but, what common drill bit should they use? I'm not sure what selection a machine shop will have. For example would a 2.75" work?
Never mounted a lens before,
Bill
Bookmarks