4x5 Gandolfi Precision Lensboard Measurements

[C. D. Keth]

I couldn't find any information on the web about older gandolfi lensboard sizes so I thought I'd post this here for future searches.

These measurements were taken from an original gandolfi board that came with the 4x5 gandolfi precision outfit I just bought.


Attachment 80031

[Emil Schildt]

If you translate those mesurements to metric, then it will make sense to me...

(Not to worry - I already have that Gandolfi...)

[C. D. Keth]

You and your base-10 logic.

[Bill_1856]

Whole Plate Gandolfi lens board measures 100mm x 140mm. No bevels.

[BradS]

The original measurements appear to have been lost (in the attachment to the OP perhaps?).
By my reckoning, they are as follows:

height: 2.73 inches
width: 3.75 inches (not critical)
thickness: 0.23 inch

both of the long edges are slightly beveled - front surface is taller than the rear.

I've posted photos here but, I'll probably not leave them there very long.

I'm looking to purchase a few lensboards....