Results 1 to 7 of 7

Thread: Amidol Woes

  1. #1
    God loves a tryer Scotty230358's Avatar
    Join Date
    Nov 2008
    Location
    Lancashire UK
    Posts
    185

    Amidol Woes

    I have been experimenting with Fienne's Amidol developer as it gives very satisfying cold tones. However I am having difficulty with pink staining. My first attempts were with Fomatone MG and then with Adox Vario Classic. Both papers exhibit the same problem.

    I mix the main constituents with water at 70 degrees F and then mix the amidol in a small amount of chilled water as I understand amidol does not dissolve well in hot water. When I mix it the colour is a moderately deep rose. I use a citric acid stop bath but this does not seem to mitigate the pink stain. After washing the stain is diminished but the whites are never truly white.

    Any advice from amidol users would be greatly appreciated.

    Thank you.

    Adrian

  2. #2
    Drew Wiley
    Join Date
    Sep 2008
    Location
    SF Bay area, CA
    Posts
    18,377

    Re: Amidol Woes

    ??? First of all, an acid stop bath is useless because, unlike most developers, amidol does not need an alkaline environment (just stop with plain water). It mixes just fine
    in warm water, though I personally add it to the precursor chemistry just before the work session. Not every paper responds well to amidol. And you can cool the tone
    by substituting less benzotriazole for more KBr.

  3. #3
    Michael Jones's Avatar
    Join Date
    Nov 1998
    Location
    Nashville, Tennessee
    Posts
    583

    Re: Amidol Woes

    Quote Originally Posted by Scotty230358 View Post
    However I am having difficulty with pink staining.
    Adrian
    It sounds like you may have some of the "Chinese" amidol. Try straining the mixed amidol through a coffee filter (or filter media) to strain our any lumps & impurities.

    You are already on Michael Smith's forum and that is the most readily available source of info.

    Good luck. It does work.

    Mike

  4. #4

    Join Date
    Jun 2001
    Location
    North of Chicago
    Posts
    1,758

    Re: Amidol Woes

    I'm going from memory here, but if I remember correctly Amidol does not like rapid fix—ammonium thiosulfate—which can cause pink staining, but works best with plain Hypo.
    ____________________________________________

    Richard Wasserman

    https://www.rwasserman.com/

  5. #5

    Join Date
    Jul 2007
    Location
    Austin TX
    Posts
    2,049

    Re: Amidol Woes

    Amidol really should be fresh to avoid staining. In Chinese versions I don't think the straining will help much, again I think the age is what is more related to staining. Like Drew says use a water stop or I use citric acid bought from the grocery store in tablet form. All chemistry one shot in a tray. The technique of adding the Amidol just prior to developing is what I have done. I used B. Westons 1982 formula with a couple of citric acid tablets rather than the benzotriazole. I was not convinced that the blacks were much superior to carefully calibrated Dektol.

    Ah, the Rapid Fix possibility is interesting, I also used plain Hypo.

    Nate Potter, Austin TX.

  6. #6
    God loves a tryer Scotty230358's Avatar
    Join Date
    Nov 2008
    Location
    Lancashire UK
    Posts
    185

    Re: Amidol Woes

    Thank you for your replies.

    1. Drew - I use a citric acid stop bath as recommended by Stephen Anchell in his book "the darkroom cookbook". However this may be redundant as Fien's has citirc acid in it.

    2. Richard - I did not know that Amidol does not like rapid fix. I will buy some plain hypo and see what happens.

    3. Nathan - I understand what you are saying but according to Michael Smith he used Amidol that was packaged in 1903. I doubt my amidol is that old. I purchased it about a year ago from Silverprint.

    I

  7. #7

    Re: Amidol Woes

    Quote Originally Posted by Nathan Potter View Post
    Amidol really should be fresh to avoid staining. In Chinese versions I don't think the straining will help much, again I think the age is what is more related to staining.
    The amidol that Michael Smith uses was bottled in 1903, so I hardly think that freshness is much of a consideration here.

    The staining that I get with Chinese amidol is yellow and goes away after sufficient washing. It produces the densest blacks I've ever seen which is why I put up with all the staining (and not just of the prints - it's really nasty stuff).

    Since the OP said that the staining wasn't mitigated by the acid stop he uses, I deduce that he's getting it in the developer. Hence the fixer issue would seem moot in this case, although ammonium thiosulfate fixers do turn amidol-developed prints pink. Use plain hypo (sodium thiosulfate pentahydrate) to fix amidol prints. You might also want to try an acetic acid stop bath. That's what MAS and Paula Chamlee use.

    I suspect the culprit is the benzotriazole in Fien's amidol. Use KBr as a restrainer instead. You'll get a warmer tone, but it may solve your staining problem.

Similar Threads

  1. Amidol Concentrated Suspension
    By Jay DeFehr in forum Darkroom: Film, Processing & Printing
    Replies: 19
    Last Post: 5-Dec-2011, 19:11
  2. Amidol Popsicle
    By Andrew O'Neill in forum Darkroom: Film, Processing & Printing
    Replies: 6
    Last Post: 5-May-2009, 21:31
  3. Amidol
    By Tony Lakin in forum Darkroom: Film, Processing & Printing
    Replies: 20
    Last Post: 29-Aug-2008, 10:28
  4. Amidol dilution
    By Paul Giblin in forum Darkroom: Film, Processing & Printing
    Replies: 5
    Last Post: 13-Aug-2001, 07:07

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •