Results 1 to 4 of 4

Thread: Home made print washer

  1. #1

    Home made print washer

    In a moment of enthusiasm I built one of David Vestal's "el-cheapo" print washer s, somewhat modified to be exact. Problem: Air bubbles form on the print. I a ssume that is not good. How do the 'real' washers avoid that? I have never see n one in operation. Do they use some scheme to make turbulence that prevents it ?

  2. #2
    Old School Wayne
    Join Date
    Dec 1999
    Posts
    1,175

    Home made print washer

    With my Versalab I take the rack and tap it against the bottom several times to dislodge bubbles that form when the tank is filling. After the tank is filled, I dont get any more bubbles. If you are, your problem might not be in the washer but further up the line

    And no, that is not good because the bubble spots wont get washed.

  3. #3

    Home made print washer

    Air bubbles on prints are caused by disolved oxygen in the water; especially in cold winter water (cold water can disolve more oxygen than warm water); and water with Hardness levels of about 100 parts per million (ppm) or more. I draw my water from Lake Michigan and ,in the winter, have the same problem in my store bought washer. What I do is, from time to time, through the wash cycle, tap, shake and wiggle the washer as the bubbles form. Then wait for summer when there is some other problem to deal with.

  4. #4

    Home made print washer

    Actually the oxigen answer is incorrect. Let me clarify this, in Summner water degasses more oxigen and in winter the water keeps the oxigen in solution because of the lower temperature, this ranges from 6 ppm in summner to 10 ppm in winter, not enough to cause air bubbles, where Howard was partially correct was thinking of water hardness. The bubbles are formed by Carbon Dioxide which is generated when water with some hardness comes in contact with an acidic medium to generate carbonic acid which decomposes into carbon dioxide when the ph is raised, and you get to see the little bubbles....Think, high ph (developer) low ph (stop bath) low ph (fixer) then high ph (wash water) thus you can see why you are generating the bubbles. I do this for a living purifing water for nuclear plants etc, and it is part of my job to remove Oxigen and CO2. In any case, if you wish to remove the bubbles you would have to lower the ph to below 4 to keep the carbonate in acid form, not something you really want to do. So to answer your question yes the idea is to generate sufficient turbulence to prevent the bubble from forming on the print, if they form on the sides of the glass who cares?

Similar Threads

  1. springs for home made 5x7
    By mark anderson in forum Cameras & Camera Accessories
    Replies: 6
    Last Post: 27-Jan-2006, 09:08
  2. Another home-made digital scanning back
    By QT Luong in forum Digital Processing
    Replies: 4
    Last Post: 20-Jan-2006, 13:11
  3. Has anyone built a Bender home made
    By Alan Chandler-Smith in forum Cameras & Camera Accessories
    Replies: 11
    Last Post: 5-May-2005, 01:10
  4. sticky plastic sheets for home made grids
    By Darin Cozine in forum Cameras & Camera Accessories
    Replies: 11
    Last Post: 16-Oct-2003, 03:24
  5. Home made focussing system
    By julian_858 in forum Cameras & Camera Accessories
    Replies: 9
    Last Post: 7-Jan-2000, 13:34

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •