Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Vignetting due to the sunshade,tilts,shifts and swings

  1. #1

    Vignetting due to the sunshade,tilts,shifts and swings

    Hi, I'm concern, as a beginner, about vignetting. Whith a sunshade on my lens, does vignetting occur sooner when you apply swings, tilts or shifts? How to avoid it? Should I stop down, until I could se all the shutter blades through the corner s of the ground glass? Help! Thank's to all of you. Daniel Luu Van Lang

  2. #2

    Join Date
    Sep 1998
    Location
    Loganville , GA
    Posts
    14,410

    Vignetting due to the sunshade,tilts,shifts and swings

    You don't use lens hoods with vieww cameras. They use Compendiums, Proper compendiums can not vignette if properly used.

  3. #3
    Robert A. Zeichner's Avatar
    Join Date
    Feb 1999
    Location
    Southfield, Michigan
    Posts
    1,129

    Vignetting due to the sunshade,tilts,shifts and swings

    No amount of tilting or swinging at the rear will change the relationship of the shade to the front of the lens. The thing you must keep in mind is that if the lens has coverage beyond what you can see when the camera is neutral, raising or dropping the front or rear, shifting either, or swinging or tilting the front can move the "hidden" portion of the lens projection into view where, if the shade is too long for the lens' angle of acceptance, you may very well see vignetting.

    The simplest sunshade is your hat or a piece of black cardstock that you carry with you into the field. If you stand off to the side of your camera and hold the card or hat in such a way as to block any direct rays of sun from striking the lens (you can observe this) you will realize at least the most important value of a sunshade. One further question is whether there is any additional gain from having a shade completely surround the lens at all times. Technically, if a lens has flare, you should be able to help increase contrast by preventing any light that has nothing to do with the subject from striking that lens. Here, an adjustable shade or compendium would be of value. The only caviat is that you must carefully calibrate such a shade so you know exactly how to adjust it for each lens you use or you could experience vignetting.

  4. #4

    Vignetting due to the sunshade,tilts,shifts and swings

    No lens hoods with large format??? Guess I've been doing it wrong for over 30 years.

    Yes Daniel, the cut out corners are used to check for vignetting.

  5. #5

    Join Date
    May 2006
    Location
    Arizona
    Posts
    377

    Vignetting due to the sunshade,tilts,shifts and swings

    Well Daev you're lucky that Bob was around to set you straight. If you ask nicely maybe he can do something about that first name of yours.

  6. #6

    Join Date
    Jan 1998
    Posts
    262

    Vignetting due to the sunshade,tilts,shifts and swings

    Daniel,

    Yes, it is in fact not possible to make a large format photograph with a traditional lens shade. You must use a compendium shade. To get one, simply send a whole lot of money to hpmarketingcorp.com. Without one of these very important items, your pictures will be very ugly and you will hate them, as will other people. Thankfully, hpmarketing.com is here to make your pictures beautiful. For a price.

  7. #7

    Join Date
    Sep 1998
    Location
    Loganville , GA
    Posts
    14,410

    Vignetting due to the sunshade,tilts,shifts and swings

    "To get one, simply send a whole lot of money to hpmarketingcorp.com."

    Once again you don't send us money. You send us requests for brochurtes.

    We sell to camera stores not individuals.

    Complicated Huh?

  8. #8

    Vignetting due to the sunshade,tilts,shifts and swings

    To help check if you will get vignetting or not, after you have done all your corrective movements, peer through the "cut out" corners of the ground glass. If you don't see the lens opening... you will get vignetting. Choose a different lens shade or readjust your compendium.

  9. #9

    Join Date
    Dec 1997
    Location
    Baraboo, Wisconsin
    Posts
    7,697

    Vignetting due to the sunshade,tilts,shifts and swings

    In an apparent effort to be completely unhelpful, Bob has overstated the case. You can use lens hoods with large format lenses -I do it all the time - but they do present the risk of vignetting with front standard movements. The easy way to check is, as you obviously already know, to look at the lens opering through the corners of the ground glass. Start with the aperture wide open and gradually stop down until you no longer see a football shape. The other thing to be aware of is that using your hand or a dark slide or a hat as a substitute for a lens hood often won't work. Tose things will work fine in a situation where the problem is direct sunlight striking the lens. But that isn't the situation in which you most need a lens hood or shade. The time when you really need a hood or shade is in bright diffused light, when non-image forming light is striking the lens from all directions. People don't spend a lot of money on hoods or shades because they're ignorant of the fact that they can use their hand to shield the lens from direct sunlight. They buy hoods or shades because there are many situations in which your hand or a dark slide or something similar won't work.
    Brian Ellis
    Before you criticize someone, walk a mile in their shoes. That way when you do criticize them you'll be
    a mile away and you'll have their shoes.

  10. #10

    Join Date
    Sep 1998
    Location
    Loganville , GA
    Posts
    14,410

    Vignetting due to the sunshade,tilts,shifts and swings

    What is a compendium?

    A compendium is a fully adjustable bag or bellows that attaches to the camera standard (not the lens) that is adjustable so that what ever move you do - front or back - it can be adjusted so that it does not intrude into the image area. Being adjustable means not only for position but also for length. And frequently compaendiums come with or offer masking blades to restrict any oblique light. A proper compendium will have an opening the same size as the film in use (or proportional to it with masks) and an extension equal to the lenght of the bellows of the camera when the image is in focus. Meeting these conditions any light that does not directly strike the film to make the exposure is blocked from hitting the lens surface so flare is reduced and sharpness is enhanced due to better contrast.

    A lens hood can not do what a compendium does and very few large format camera manufacturers sell lens hoods (even Linhof who has their drop-in filter hood set does not recommend its' use in lieu of a compendium.

    Yes for you outdoor people it adds weight, bulk and setup time and Ansel didn't use one. But it works better then cardboard, hats, hoods and hands. It is repeatable and easy to use once you get use to it and some increase your filtering options with holders behind the compendium.

Similar Threads

  1. Tilts and swings with those little digibacks...
    By Frank Petronio in forum Cameras & Camera Accessories
    Replies: 25
    Last Post: 14-May-2006, 14:05
  2. Ebony View Cameras - Assymetrical Tilts/Swings
    By paul owen in forum Style & Technique
    Replies: 3
    Last Post: 13-Nov-2005, 15:39
  3. Importance of lensboard size on tilts and swings with W.A. lenses
    By Jean-Louis Llech in forum Cameras & Camera Accessories
    Replies: 8
    Last Post: 8-Nov-2003, 07:02
  4. Asymetric Swings and Tilts
    By Kevin J. Kolosky in forum Style & Technique
    Replies: 12
    Last Post: 29-Jan-2001, 14:33
  5. Replies: 1
    Last Post: 7-Jun-2000, 18:08

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •