Kodak 1A Grey Bullet Safelight 1 by Nokton48, on Flickr
This one is the Lowes red LED with Kodak 1A red filter. This is 6-7 feet above my film cutting area and -ZERO nada- fog with MIN-R and HRU. Bright enough to comfortably cut film with no issues whatsoever. Thanks to Jason Lane for steering me to this thingee. Not inexpensive but it works great. I think Jason uses this to coat his ASA 25 Speed dry plates. His old safelight would fog the high speed plate emulsion. So if it works for coating, it will work for loading and developing.
Kodak 1A Grey Bullet Safelight 2 by Nokton48, on Flickr
And this second one is 6-7 feet above my developer tray and again -ZERO nada- fogging of HRU, MINR, and Ilford 50 ASA Ortho. Routinely I go as long as twenty minutes in the dev tray, lifting the neg out of the cesco flat bottomed tray by the dental clips, to carefully inspect the deep shadow areas.
This is the red 3w LED from Lowes. Road tested by me.
https://www.lowes.com/pd/Energetic-W...ulb/1000623747
Bookmarks