Print washing in a Jobo?

[Martin L.]

Hi,

Noobie question here. Anybody washing fiber prints in a JOBO drum? If so what do you suggest as a normal wash procedure? I was thinking 4 minutes water, 4 minutes hypo-clear and 2-2 minute washes all using 300ml of water or hypo.

Advice is always appreciated

Martin

[Brad Rippe]

I don't have a jobo, but the problem I see is you'll only wash one side of the print, you need good circulation all around a print. The simple print washers are the way to go.

Good idea though.
-Brad

[Nick_3536]

I wash my colour prints in the drums.

I do a series of 30 second washes. Fill spin dump.

I then stick them into a holding tray and run the water a bit to make sure the back is also done. It's over kill for RA-4 but might not be enough for fiber.