Results 1 to 5 of 5

Thread: Parallel Standards

  1. #1

    Join Date
    May 2000
    Posts
    37

    Parallel Standards

    Hi,

    My old Deardorff has no detents to indicate parallelism between the planes of th e front and rear standards.

    I can guess at the positions real good, but I'd also like to put some marks on t he camera that indicate "0" positions.

    I have heard of some kind of mirror set-up that can be attached to a view camera and used to determine the parallel locations of the planes.

    I was wondering if anyone has used the device and can offer suggestions concerni ng where to buy one.

    Thanks.

    Jason

  2. #2

    Join Date
    Mar 1999
    Posts
    769

    Parallel Standards

    I think you're referring to the zig-align mirrors. Try http://www.gassers.com/ZigAlign/ZigAlign.html I've also remember reading an article by Howard Bond where he talks about constructing something similar to test enlarger alignment. Good luck. DJ

  3. #3

    Join Date
    Dec 1999
    Location
    Forest Grove, Ore.
    Posts
    3,696

    Parallel Standards

    Sears sells a small "angle-finder" that uses a bubble and an attached protractor that can be used to level cameras. Assuming both the front and rear standard are at the same angel, they should also be parallel. They're about 3 inches square, and they cost only a few dollars.

  4. #4

    Parallel Standards

    just use a stick and make sure that the mark on the stick is the same at the top of the camera standards as the bottom of the standards.

  5. #5

    Join Date
    Jul 1998
    Location
    Lund, Sweden
    Posts
    2,209

    Parallel Standards

    You can easily make your own alignment mirrors or get a glasscutter to cut them to size from mirrored tiles. The first should be the size of a lensboard (or large enough to cover the hole on a spare board). The second should be the right size to replace your ground glass panel. Drill a hole in the middle of one of the mirrors, or carefully scratch away the coating to reveal bare glass.

    Mount the mirrors, one one each standard, with their silvered surfaces facing inwards. Look through the hole and you should see an infinite line of image holes caused by the multiple reflections off the two mirrors. Adjust the standards so that the hole images line up and bingo, your standards are aligned.

    If you're a cheapskate like me you can do the same trick with two scrap CDs.

    If it's too dark inside the camera you can remove the bellows, or mount a laser pointer shining through the hole and look for the reflected spots. If you do the latter, you'll need at least a T-square to make sure the pointer is perpendicular to the glass.

Similar Threads

  1. Parallel lines and circles
    By Stew in forum Style & Technique
    Replies: 8
    Last Post: 30-Jun-2005, 11:17
  2. Establishing Parallel Standards On Drop-Beds
    By jhogan in forum Style & Technique
    Replies: 11
    Last Post: 21-Jan-2005, 15:56
  3. Limber B&J standards
    By Kaatharine Thayer in forum Cameras & Camera Accessories
    Replies: 8
    Last Post: 24-Mar-2002, 02:18
  4. Linhof Parallel Alignment Mirror
    By dileep prakash in forum Gear
    Replies: 1
    Last Post: 13-Mar-2001, 06:06
  5. Parallel back to parallel wall -- how do you know?
    By Dean Lastoria in forum Style & Technique
    Replies: 6
    Last Post: 23-Aug-2000, 13:21

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •