Kodak 2-D Bellows Replacement Question

[GhoSStrider]

Hello All,

I recently picked up a new set of bellows for my Kodak 2-D with the frames already installed. Getting the old bellows off of the front standard was a simple matter of removing 9 screws. However, I can’t figure out how the bellows attach to the rear standard. I see a number of tacks in the frame but was assuming that these were just to hold the fabric to the frame? Or do I need to remove each and every one of these tacks to remove the frame from the standard.

Thank you in advance for any assistance!

Chris
West Chicago, IL

[Jon Shiu]

I think the rear frame is also attached by screws. You may also have to scrape out some filler.

[diversey]

You can find the screws inside frame. See a picture below. Make sure you use wood filler to fill the gap between the rear stand and the rear frame to avoid light leak.

[GhoSStrider]

You can find the screws inside frame. See a picture below. Make sure you use wood filler to fill the gap between the rear stand and the rear frame to avoid light leak.

Found them! Thank you for the help!