Originally Posted by
Dugan
I have no experience with Linhofs, but I have used the infinity stops on my Speed Graphics.
My methodology is:
Set up the camera with the lens.
Open aperture to maximum, shutter open on T.
Focus the camera, using the ground glass, on something Very Far Away.
Adjust infinity stops on the rail so that they touch the front standard, and tighten down gently.
Speed Graphics use pointed screws that leave divots in the yoke (rail), not sure if Linhofs do the same....
I then mark on the yoke with fine tip Sharpie what lens that pair of infinity stops is for.
Hope this helps.
Bookmarks