Linhof Technika V + Angulon 90mm f6.8 - Which Lens Board?

[stephenmcateer]

I have purchased a Technika V and, separately, a Schneider Angulon 90mm 6.8 to use with it.

Can anyone tell me which lens board I should get if I want the lens to be able to stay on the camera with the front closed up?

[I hope the camera will actually be able to fold up with this lens on board…]

Thanks for any info.

[Bob Salomon]

001015

[stephenmcateer]

Thanks Bob.

[Bob Salomon]

Thanks Bob.

Make sure if it is an old one that it is for Compur shutters, not Copal.
If it is a recent one it won’t matter.

[stephenmcateer]

Make sure if it is an old one that it is for Compur shutters, not Copal.
If it is a recent one it won’t matter.

Okay thanks for that Bob. Off to search eBay.

[stephenmcateer]

Think this would work Bob? Thanks. -

https://www.ebay.co.uk/itm/334247402134

[I don't see the 001015 part anywhere other than Linhof or B&H and the price is out of my reach...]

[Bob Salomon]

Think this would work Bob? Thanks. -

https://www.ebay.co.uk/itm/334247402134

[I don't see the 001015 part anywhere other than Linhof or B&H and the price is out of my reach...]

Probably, but don’t you have a Compur shutter?

[stephenmcateer]

Probably, but don’t you have a Compur shutter?

Yes — Compur #0.

From what I could see on Google, the hole size for this shutter is 34.6mm ,which is the same as Copal #0. Hope that's right.

[Bob Salomon]

Yes — Compur #0.

From what I could see on Google, the hole size for this shutter is 34.6mm ,which is the same as Copal #0. Hope that's right.

Yes, but if that board is for the Copal then your shutter may rub against the side of the recess.

[LabRat]

Besides diameter, the other thing to check for when using Compur/Copal shutters is board mounting thickness... The shutters have a short thread behind that the retaining ring screws to, and if the board is too thick there, it will not or barely thread safely so the shutter is held down properly... And lens cells that are large/cone shaped will sometimes not screw down completely if board hole is recessed, but makes contact with recess hole...

But your Angulon is ok as the cells diameter is not much larger than the shutter, but SA types could be...

Steve K