Piece fell out from my Grafmatic

[Spare Tire]

https://youtu.be/Ir2W_YCLQMg

So what do I do with this metal piece with a bit of velvet cloth attached to it?

[Havoc]

You really should put it back as this is a light seal.

[Conrad . Marvin]

Goes under the center bit with the “patent info 4x5 printing “ not in the end. But, I have not had one of these apart in a really long time. I would carefully remove the two screws on each side and pull the two halves apart. Then maybe you can see better what’s what. Nothing to loose.

[Alan9940]

It's been quite awhile since I've disassembled a Grafmatic, but that piece looks like the felt light seal that sits under the septum tray where it slides in/out. Kind of hard to explain here. If you PM your email address, I can send along a service manual which should help you fix it.

[Gord Robinson]

This may be of help
http://www.southbristolviews.com/pic...c45service.pdf

[Spare Tire]

felt light seal that sits under the septum tray where it slides in/out

I tried shoving it back under the whole septum tray. It closes and cycles alright but sometimes it slides back out and will jam.
https://youtu.be/zbQOuRbO4fY

I wonder if it's not supposed to be glued down or something. Anyways thanks for the ideas and resources. Will try not being lazy and take it apart when i have a moment.

[j.e.simmons]

Ask on graflex.org.