Waterhouse templates

[Kiwi7475]

Hi,

I know I can probably DIY this myself, but I was wondering if someone has or is willing to provide the dimensions or even a simple template to build the Waterhouse stops for a Dallmeyer 3D and a 4D.

Even a picture of a paper with a pencil tracing of the edges and hole(s) would be very useful.

Thanks in advance!

[Len Middleton]

Kiwi,

I have done a drawing for a set for my Ross No 3 Universal that you are welcome to use as a starting point.

The straight vertical sides are the width of waterhouse stop opening, and the bottom radius is that of the internal of the lens.

I have not yet had these cut, as waiting for the library to open again to get access for the 2D laser cutting table in the maker-space, but could farm them out to a shop that does laser, water jet, or abrasive 2D cutting.

Hope that is helpful,

Len

[Kiwi7475]

Kiwi,

I have done a drawing for a set for my Ross No 3 Universal that you are welcome to use as a starting point.

The straight vertical sides are the width of waterhouse stop opening, and the bottom radius is that of the internal of the lens.

I have not yet had these cut, as waiting for the library to open again to get access for the 2D laser cutting table in the maker-space, but could farm them out to a shop that does laser, water jet, or abrasive 2D cutting.

Hope that is helpful,

Len

This is a great starting point for me, thank you very much Len!!

[Len Middleton]

Feel free to PM me if you have any questions

[Drew Bedo]

I used heavy card stock to make a template.