Good evening all,
I have a very dumb question for you all. I have a Jobo 3006 that can accept both 4x5 and 5x7 sheets. After reading the manual (that is a bit unclear to me regarding this issue. I quote “ When loading 4 x 5 inch film, push the material into the cylinder only until it is flush with the top of the cylinder. When loading the Drum with films of sizes 8 1/2 x12", 8x10" or 5x7", push the material to the bottom of the Drum cylinder.” ), I assumed that 5x7 sheets should be loaded « laterally », meaning the 5 inches edge is vertical and the notches are at the bottom of the tank.
My first try with test sheets was successful and I just processed 2 sheets that came out very unevenly developed.
I believe the sheets might have overlapped in their container. Should the sheets be actually loaded vertically (7 inches side vertical) even though 2 inches would stick out of the container?
I used 500ml of pyrocat hd as my developer.
Thank you for your help
Bookmarks