Results 1 to 5 of 5

Thread: Question Re Zone VI Enlarging Timer

  1. #1

    Join Date
    Feb 2001
    Location
    Blue Jay, CA
    Posts
    2,260

    Question Re Zone VI Enlarging Timer

    My original foot switch has just fallen apart after many years of use. Is this just a momentary contact switch? Make the connection by pushing down thus resetting the counter to zero or causing it to start to run? If you know. Thanks.


    PS: I meant to ask about the DEVELOPMENT timer, not the enlarging timer. Sorry. Same foot switch, I think.

    Kevin

  2. #2

    Re: Question Re Zone VI Enlarging Timer

    Both are momentary contact switch
    Richard T Ritter
    www.lg4mat.net

  3. #3

    Join Date
    Feb 2001
    Location
    Blue Jay, CA
    Posts
    2,260

    Re: Question Re Zone VI Enlarging Timer

    Thanks, Richard. That will make it easy.

  4. #4

    Re: Question Re Zone VI Enlarging Timer

    You can use an off/ on foot switch with the developing timer.
    That is how my timer is set up.
    Richard T Ritter
    www.lg4mat.net

  5. #5

    Join Date
    Feb 2001
    Location
    Blue Jay, CA
    Posts
    2,260

    Re: Question Re Zone VI Enlarging Timer

    You mean supply power to the unit at the start of a development cycle and eliminate the reset to "000" step?

Similar Threads

  1. Zone VI Enlarging Timer Repair
    By Stephen Collector in forum Darkroom: Equipment
    Replies: 3
    Last Post: 24-Aug-2015, 17:03

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •