Originally Posted by
labrat
if you look at the gg focusing panel, you see the the arms that come off it, and near the panel side you see a little tab sticking out of them... There is the spring on the inside of the panel that needs to be lifted and held up until you can fold the arms down and the spring then will sit on top of those little tabs on the arms... Wrap a flat screwdriver with tape (to prevent scratching the panel) and lift them, then stick something like a point of a chopstick inside to hold it up, and try to manouver the tab under it... This may take a few tries, but it will go without removing spring... The arm is soft steel and bends easily, but sometimes you can bend it slightly out of the way, get the spring on, then bend it back into normal position... Careful you don't hit the gg and damage it, so you might remove it before repair...
Note that these do not like holders too thick in them, and might damage the above assembly, so always use care when using these...
Good luck!!!
Steve k
Bookmarks