Is it possible to make a pressure fitted tube cap with light traps that would fit various standard plumbing ABS in 3" or 4" diameters. The user could cut to any desired length. I assume a modular tube system would probably leak if threaded together. I used to have a metal 3 reel system with this type of rubberized fitted cap.
The magic you are looking for is in the work you are avoiding.
http://www.searing.photography
Has anybody experienced these types of imprints on their negatives with the SP810?
Look at these stretch mark-like and worm-like patterns in the attached photos.
I've ruled out temperature shift reticulation as I did two tests already with consistent temperature.
Developed using Pyrocat-HD 1:1:200, 60min semi stand development.
Sent from my Pixel 2 XL using Tapatalk
Not me.
Kent in SD
In contento ed allegria
Notte e di vogliam passar!
jurgen,
Did you get our email with questions?
You're doing semi-stand development with limited agitation; are you agitating for the first 30 seconds to make sure the film breaks free from the bottom of the tray?
Tim
Jurgen,
Per your email, the issue is on the emulsion side and you processed emulsion side up. So it must be related to the chemistry, after all, at that point it's just a tray. Don't know how that dilution would behave; you might need more than 400ml.
Tim
Should I buy an SP-810 for £180 for a 'an new' Paterson Orbital for £100 to develop whole plate film? I'm surprised I can't find a comparison of these two anywhere!
Bookmarks