Hi all,
WARNING: You are about to read a line of rookie questions!!! Get ready....
Happy holidays! I recently posted a question in the Camera section of the forum. I got great feedback from a lot of folks. Basically, I have not started in LF photography, but looking into what involved. I understand the front end of the process reasonably well, right up to "click" of the shutter. Then what?
I was asked in the thread, what was I planning to do, "scanner, enlarger, or contact printer?" In large part, that's what I'm trying to understand better. I don't quite understand the details of any of these methods, the pros and cons and the cost involved.
I'm ok with re-learning the developing part of the process that yields a negative, but then what?
Can anyone share their suggestions on each of these post processing methods and what's involved as well as the cost?
If you can point me to a good source of reading material too!
Many thanks.
Adam
Bookmarks