I think the rubber cap I made conforms and fits a little too well. Sliding it on and off causes a little bit of suction and is causing the radial drive on the lens to move..... back to the drawing boards.
As `the whole thing is plastic/rubber, can you drill a small hole then fix a flap to the inside of the cap covering the hole in a springy manner. Pushing the cap on will keep it sealed, while pulling the cap off will allow the flexible flap to 'fart' some air in to the cap, therebye reducing the negative pressure.
Google 'elastic bowl covers' or visit a big-box store or a local grocery and be happy.
Why make simple so difficult?
Reach out to Anton Orlov. He has a fellow in the Ukraine who makes beautiful, custom caps for a reasonable price. I have them for the front and back of each of my best lenses.
Cameron Cornell
Washington State
www.analogportraiture.com
I actually wound up drilling a hole at a right angle in the round knob and then one down the center into the hand. It turns out that the 3D print utilizes a honeycomb paternities inside the larger portions top save weight and material. That is acting like a natural light baffle and I don't have any suction issues. Pretty cool. I definitely think the leather one I made for my voigtalnder looks better, but this 3D printed rubber lens cap works just as well without the headache of stretching leather, laminating cardboard, etc..
Bookmarks