Results 1 to 6 of 6

Thread: Fujimoto CP51 info

  1. #1

    Join Date
    Oct 2018
    Posts
    4

    Fujimoto CP51 info

    A client has left us with a CP51 main module for repair
    The issue is that it is in poor condition and we have a manual but no technical
    info on this unit ie Circuit diagrams Etc to get this unit repaired
    Any help greatly Appreciated Gary Anstis AIM Calibrations - Australia

  2. #2

    Join Date
    Feb 2010
    Posts
    1,044

    Re: Fujimoto CP51 info

    I have the CP-31 service manual, and CP-51 owners manual, but neither have full schematics.

  3. #3

    Join Date
    Oct 2018
    Posts
    4

    Re: Fujimoto CP51 info

    I have these also thanks for reply
    Issue is that display is faulty and planning to replace controllers
    Just trying to workout what wire does what
    Will keep trying

  4. #4
    Bob
    Join Date
    May 2006
    Location
    Maryland
    Posts
    222

    Re: Fujimoto CP51 info

    My display acts up once in a while looking dead. Pushing the reset buttons usually gets it back working in case you haven't tried that.

    You might also try a pm to Greg Blank. He used to service them for Omega Satter, not sure if he is still on the forum since he hasn't posted lately.

    There is a battery built into the display that could be the problem. Omega Satter may have access to the schematics.

  5. #5

    Join Date
    Oct 2018
    Posts
    4

    Re: Fujimoto CP51 info

    Quote Originally Posted by RPNugent View Post
    My display acts up once in a while looking dead. Pushing the reset buttons usually gets it back working in case you haven't tried that.

    You might also try a pm to Greg Blank. He used to service them for Omega Satter, not sure if he is still on the forum since he hasn't posted lately.

    There is a battery built into the display that could be the problem. Omega Satter may have access to the schematics.

  6. #6

    Join Date
    Oct 2018
    Posts
    4

    Re: Fujimoto CP51 info

    Display was dull and hard to read, had only one tank heating, replaced battery and now cant get into setup to set tank temps.
    Have sourced temp controllers and was looking at retro fitting these to get unit functioning but without circuit diagram it is a bit of a gamble
    Any suggestions appreciated
    Gazwod Australia

Similar Threads

  1. Fujimoto CP51 processing questions?
    By Stpephen Willlard in forum Darkroom: Film, Processing & Printing
    Replies: 5
    Last Post: 31-Oct-2006, 18:20
  2. fujimoto CP51 vs Colex Studio 50M
    By Tom Hanly in forum Darkroom: Film, Processing & Printing
    Replies: 2
    Last Post: 1-Apr-2005, 22:55

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •