Results 1 to 3 of 3

Thread: Folmer Schwing 7x17 Film Holders

  1. #1
    Smitty's Avatar
    Join Date
    Jun 2014
    Posts
    132

    Folmer Schwing 7x17 Film Holders

    Hello All,

    Is there a standard size on all 7x17 Folmer Schwing film holders or might they vary in size? The holder that came with my camera measures: 19 3/32 from flap end to outside edge of lock groove with 19 1/4 to the edge of the holder before dark slides. Width of the holder is 9".
    I have another holder thicker I think made for glass plates which measures about the same as above but with a narrower width of 8 5/8". There is some side to side slop on that one. It will would not give full exposure to the film in both top and bottom areas at the same time (holder protrudes into film plane).
    I am a newbe in ULF but not to large format.

    Thoughts? Thanks, Steve

  2. #2

    Re: Folmer Schwing 7x17 Film Holders

    The plate holder at 8 5/8 is of the standard size use by US camera makers.

    You could add a strip to each side to make the width of the holder to 9 inches.

    The other option is to have the back modified to take the more standard size. Makes finding holders easier.
    Richard T Ritter
    www.lg4mat.net

  3. #3
    Smitty's Avatar
    Join Date
    Jun 2014
    Posts
    132

    Re: Folmer Schwing 7x17 Film Holders

    Richard,
    Thanks, this information clears things up a bit.
    Please check your gmail for a message.

    Thanks, Steve

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •