Re: MOD54: 2 kinds of plastic have been used. Should I care? Why?
I haven't seen the newer version but I am quite certain that dropping my original version might be fatal (to it, not to me). The plastic is quite hard and likely somewhat brittle.
Re: MOD54: 2 kinds of plastic have been used. Should I care? Why?
I bought one of the early ones . It had stress whitening from being stuck in the injection molding tool. You could see where the ejector pins pushed on the part. I sent it back to B&H . I have been very pleased with Jobo 2509n reels . NOTE I USE IR GOGGLES . I don't think I could load either without the goggles .
I'm hooked on the Jobo processor and tanks. However I developed tons of sheets with hangers and hard rubber tanks .
Best regards Mike .
Bookmarks