Went to do some color developing and I'm having an issue with my heater recirculator. I'm hoping maybe someone can help.
This unit has been rock solid since I bought it used, about 3 years ago. Today it suddenly won't heat water past about 90-95 degrees F. I opened it up and fiddled with the "Gain" knob on the temperature control unit, to no avail. It's set all the way up there and on the knobs.
I can't seem to find my instruction manual and there's barely a trace of this unit online. Any idea what the problem could be? Something I could try to fix? I jiggled some wires around but everything seems to be connected right. The red light turns on and off once it reaches peak temperature and maintains that temperature, but it's just a bit lower than optimal temperature for color work. Did some non-critical C-41 this evening with extended development, I'll see how the colors are when it dries.
Perhaps it's just given up the ghost. I hope not - but if so, suggestions on alternatives would be welcome.
Bookmarks