Results 1 to 6 of 6

Thread: Adjusting Beseler 45V-XL spring tension.

  1. #1

    Join Date
    Apr 2013
    Posts
    184

    Adjusting Beseler 45V-XL spring tension.

    I am in the process of converting a 45V-XL into a copy stand. I am just about done, but would like to lessen the spring tension of the carriage. Even with a heavy camera mounted, the carriage still shoots up too easily. Short of adding more weight within the carriage, is there a way to adjust the tension of the coil springs?
    I don't have a manual handy. If there is literature about this particular issue, a link would be appreciated.

  2. #2
    Jon Shiu's Avatar
    Join Date
    Nov 2003
    Location
    Mendocino, California
    Posts
    1,273

    Re: Adjusting Beseler 45V-XL spring tension.

    I think the usual way is to add weights. Could you use only one spring?

    Jon
    my black and white photos of the Mendocino Coast: www.jonshiu.com

  3. #3

    Join Date
    Feb 2001
    Location
    Blue Jay, CA
    Posts
    2,251

    Re: Adjusting Beseler 45V-XL spring tension.

    I think it will get cockeyed with one spring. I think you just need to add weight to avoid a camera catapult. As I recall the manual, it just tells you how much weight to particular negative housing/stages, not relative to numerical weights.

  4. #4

    Join Date
    Jan 2012
    Location
    NEW YORK
    Posts
    261

    Re: Adjusting Beseler 45V-XL spring tension.

    A VXL has some flat steel plates on the inside of the head chassis - you could check to see if they have been removed. They were to help balance the load for the different Beseler heads that could be matched to the chassis.

  5. #5
    Jac@stafford.net's Avatar
    Join Date
    Dec 2012
    Location
    Winona, Minnesota
    Posts
    5,410

    Re: Adjusting Beseler 45V-XL spring tension.

    Springs can be replaced with lighter versions.

    Springs can also be weakened by carefully applying heat.

  6. #6

    Join Date
    Aug 2007
    Location
    Montgomery, Il. USA
    Posts
    551

    Re: Adjusting Beseler 45V-XL spring tension.

    Any way you decide, be really careful with the springs.
    They can really hurt whether it's fingers or jaw.
    I'd think the safest way would be to weight the head.

Similar Threads

  1. Beseler 45MX - Leaf Spring, How to Put Back!
    By dodphotography in forum Darkroom: Equipment
    Replies: 4
    Last Post: 16-Apr-2014, 11:35
  2. How to re-tension wire locks on film holders.
    By Uri A in forum Cameras & Camera Accessories
    Replies: 9
    Last Post: 30-Apr-2011, 14:17
  3. Aperture knob tension on Copal shutter
    By jeroldharter in forum Gear
    Replies: 4
    Last Post: 26-Sep-2009, 12:10
  4. Replies: 8
    Last Post: 1-Jan-2009, 11:41
  5. Adjusting lever tension on Linhof 3-D Head
    By Frank Petronio in forum Gear
    Replies: 1
    Last Post: 14-Aug-2007, 01:07

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •