Does anyone know an 8x10 back from a Kodak 2D or similar camera would fit a Seneca/National. Looking at photos it seem as if it would. I've attached a photo of my current back (minus ground glass) and camera rear. If so, my next question will be posted in the FS/WTB Forum. Thanks in advance for any advice/suggestions.
Measure and post all dimensions. Some of these type backs do interchange and some can be easily adapted.
I have an Eastman back fitting exactly on an Ansco studio and I bought it by dimensions.
Pin distances in all dimensions.
Rebate edges.
OD and light trap ID.
Thanks Randy, will do.Originally Posted by Randy Moe
So, here are the measurements as close as I could get them.
Last edited by jonesp; 4-Apr-2014 at 09:23. Reason: Measurement Update
Hi, the 2D back is about 11-1/2" to 11-9/16" and inset part is 11".
Jon
my black and white photos of the Mendocino Coast: jonshiu.zenfolio.com
Posting Permissions
Reply With Quote
Bookmarks