Hi,
I'm looking for someone who can make a 2 or 3 of custom flanges for me. Brass or aluminum is fine. The flange diameters range from about 3 inches to 8 inches.
Thanks
Rob
Hi,
I'm looking for someone who can make a 2 or 3 of custom flanges for me. Brass or aluminum is fine. The flange diameters range from about 3 inches to 8 inches.
Thanks
Rob
There's another current thread about flanges, you might look there.
Ian
I did and didn't get anywhere, so hence my direct appeal for someone...
I went to a local engineering workshop and they said yes they could make me flanges, they charge by the hour plus materials. As their hourly charge is less than the cost of a flange from SK Grimes I can get a number of flanges made quite reasonably particularly as I need a few the same size.
Ian
I second the local metal shop; for $100 they made me a flange, enlarged the hole in my Technika board, and expertly mounted the two together.
Bookmarks