Hi Im using a Linotype-Hell Topaz Scanner with Linocolor 4 software.
I wanted to compare my prints and 4x5 negatives so i tried scanning both.

The print scan fine and beautifully.
However the negative scans with a very blue hue.

I have read somewhere that it is because of emulsion order with film negatives reading blue, green, red (in that order).
Therefore the blue receives the most light and red the least, resulting in the lack of yellows and reds.
I tried pulling down blues with curves but it is getting no where close to the print scan and im losing the gradations.

Im sure this is something that may be apparent in other scanners as well. How do i resolve this issue? Is it something that can be adjusted during scan?

Thank You