Color Services. An excellent lab, very nice people, used to dealing with professionals, artists and galleries.
http://www.colorservicesllc.com
Type: Posts; User: Peter Lewitt; Keyword(s):
Color Services. An excellent lab, very nice people, used to dealing with professionals, artists and galleries.
http://www.colorservicesllc.com
Hi Spencer
Sent you a PM
Peter
The 545 is for single sheet 4x5 polaroid. That stuff is only available from leftover stock, usually at hilarious prices. It was a great system because you could change color and B&W Polaroid...
The Super Speed Graphic is the same as the Super Graphic except for the Rodenstock 135 lens, which has a special 1/1000 shutter.
Treat the lens/shutter with caution. They are delicate and not...
Color Services
http://www.colorservicesllc.com
Highly recommended. Friendly and reliable. They print entire exhibitions for a number of galleries.
Here's a scan of mine. Actual dimensions of the acetate are 3.8 x 4.8 inches, including the clear edge outside the black mask.
Jenny
Check out these pages from SK Grimes:
http://www.skgrimes.com/press/index.htm
http://www.skgrimes.com/press/pbig/opress.gif
If you have two cable release sockets your shutter should...
Thank you Joanna.
After reading your post I called Lee Filters USA and was told "that was normal" and that all filters shift over time and that you can't expect to buy one set of filters, etc,...
I don't have a baseline measurement from when they were new, only my recollection that they didn't look like this!
But I did spend a lot of time handling them back then - making positioning guides...
My Lee Neutral Density Grads are no longer neutral. This is quite pronounced and easily seen on the light table. I also confirmed it with readings with a Minolta Color Meter.
The 1 stop filter...
Does anyone have a source for a good quality accessory shoe?
I see a lot of great homemade and modified cameras, but no mention of where to find shoes that will hold a large viewfinder like a...
Kerry Thalmann's article on Nikon LF lenses is in the March/April 2003 issue of View Camera. Unfortunately, he says that Nikon didn't use chronologically sequential serial numbers, but assigned...
Lee trims the polyester filters in their packaged sets, but they are not glued.
I have had good results simply clipping all four corners and making a small v-notch on 2 sides to clear the little...
Here's print washer section of the catalog
I was going to post them here, but I haven't got them on a scanner yet.
There may be different versions as I don't see a vertical tube in the washer shown in the catalog. The working principle of...
I have a 1990 Salt Hill catalog which devotes 4 pages to the washer.
The bottom nipple is the inlet, the top is the drain.
I can scan the pages tonight and post them.
Would you like gray or black? Send me a PM and I'll mail you one.
David
Its called a Load 50 4x5 Motor Drive. I have a 1991 brochure that gives it's list price as $1875. It was sold by Apeiron, Inc. in Mission Viejo California. It runs on a 9v battery.
It was...
Mine, in a black Copal shutter(52mm front filter thread, 54mm front cap), takes a 42mm rear cap.
Color Services in Needham, MA
http://www.colorservicesllc.com/mainpage.html
Kirk
Your order of placement is correct. The hood is held in by friction with two little spring retainers. To remove pop it open and gently pull it away from the frame. The gg and fresnel are...
Ed
I use mostly Lee resin and some polyester filters. While Lee does trim the polyester filters in their packaged sets, they are not glued. I have had fine results with simply clipping the corners...
SK Grimes makes modern replacements
http://www.skgrimes.com/lensboards/index.htm
http://www.skgrimes.com/thisweek/6_17/index.htm
They do great work.
Peter
You will love this camera. The leather WA bellows works from 47 out to 210mm, then switch to the standard bellows if you need close focus with the 210.
One caution: The interior of the leather...
David
Please take this as constructive critique. Your post comes just as I am totally immersed in evaluating websites before setting up my own.
Gordon is right about the 3 second rule. ...
Scott
You're probably looking for Troy Ammons. There are a several old threads on photo.net where Troy has posted pictures. Check out these two:
...
Ed
The Lee resin filters are reasonably durable and can be cleaned, but they do scratch. I've had to replace a few of the most used filters over the years.
The polyester filters stand up...
I use drum and Imacon scans of 4x5 film for lightjet and inkjet prints, and once created, for everything requiring less resolution.
Proofs and web/email images get scanned on an Epson 3200. Right...
Ken
I've copied my manual. PM me an address and I'll drop it in the mail
Peter Lewitt
Frank
The service manual says paraffin for the edges of both the drawer and the dark slide. Rub it in and blow away any extra. They recommend Neolube, a dry film graphite lubricant, for the dark...
Murray,
Try Color Services. They are a wonderful lab outside of Boston that does processing and exhibition printing for commercial and fine art photographers from all over. They have done a lot of...