Search:

Thanks a lot, I will email him

Thanks Dan, this seems like a good starting point for some experiments. How do you read " distance diaphragme" in these specs - is that the spacing between the diaphragm and the previous element...

Hello,

I've got a Xenar 180/4.5 (marked Schneider-Göttingen Xenar 1:4,5 F=18cm) in a barrel with no aperture. It was pretty dirty, but I was able to disasemble and clean both groups nicely. I can...

Thanks a lot, David! I'll try to get it done locally, but it's getting somewhat harder to find decent machinists doing this sort of freelance work around here.

Hello,

I tried searching the forum and the web, but did not come to any conclusive information, I'm sure someone here will be able to help. I need the dimensions/specs for the flange of the 480/9...

I've actually got plenty of holders for my needs, just this one has been bouncing around in my drawer for quite a while and I always meant to look up some slides for it. Looks good enough and I'd...

Thanks for the precise numbers Daniel, much appreciated you've taken the time to do such thorough measurements. The thickness you've measured sort of matches my estimate of 0.6mm. From my experience...

It's a pretty beat up holder that's probably not going to be used much, so I decided it'd be easier to just make some from sheet metal I can source locally rather than search for spares. Probably...

Hello,

I've been searching the forum for the last hour but couldn't find conclusive information, hence the thread. Could someone with a standard Fidelity Elite 5x4 holder and a calliper measure...

90917

A portrait of my grandfather, 5x4 Fomapan 100 if I remember correctly.

Or try talking to the people there if possible to switch off the fluorescents for 5 mins. Personally I would go and talk to the caretakers to see if there's an opportunity to go there before they are...