Search:

Type: Posts; User: Silvergrain; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    1,100

    Re: Do you recommend a water filter ?

    Hello, I would recommend you get a filter; depending of course about where you are, but for tap water in limestone areas, you might get unnoticeable particles that will scratch your prints when you...
  2. Re: An actual jobo cpp2 motor replacement that exists? Check this out

    Hello,
    You'll find pretty easily the maintenance manual for CPP2 on the net. It describes the different versions/upgrades over time, wiht both old and new PC boards + schematics.

    Re. the motor...
  3. Replies
    13
    Views
    1,955

    Re: Enlarger ilford head 500

    Here's the item https://www.mouser.fr/c/connectors/power-connectors/ac-power-entry-modules/?m=Schaffner&product=Inlets

    The PSU is rated 600W, ie 2.7 a under 220V AC, so a 3A version should fly,...
  4. Replies
    13
    Views
    1,955

    Re: Enlarger ilford head 500

    It is blinded by the wires (see the highlighted zone) .. it is the mains socket itself. On the attached service manual - available on the support page of Ilford photo website...
  5. Replies
    13
    Views
    1,955

    Re: Enlarger ilford head 500

    You might want to check first the mains socket in the PSU: it has a mains filter embedded, with a capacitor that tends to leak with age, and creates problems (sometimes even burn). Given its modest...
  6. Replies
    23
    Views
    1,712

    Re: Photo Flo In Presoak OK for PMK?

    Hello,
    Besides sheet-film, I'm using photo-flo and the likes for roll-film rotating development. I put (a drop) of it in the developer with no pre-soak, which gives me very even development on 120...
  7. Re: tricking imacon software to scanning higher ppi?

    Exactly, the sensor is located behind a lens, their heights (both sensor and lenses) are varying according to the scanned format, to capture the negative field in focus; it works effectively exactly...
  8. Re: My LED enlarger lightsource instructions / Complete parts list and build

    Many many thanks for sharing the knowledge, and all the work involved in this clean presentation.

    Thinking about fitting a 8x10 enlarger .

    Best regards
    Marc
Results 1 to 8 of 10