Search:

Thanks! Will watch.

Maybe a paragraph explaining how to search - each time I do it, I get hundreds of matches and 99% have nothing to do with the reason I searched.

Here’s a picture of it (third picture has a drawing of it in use). Easy enough to 3D print.

226079

We are participating in social media right now. It's not something to trust. But it is something that can benefit most.

They have the time - they are tuned into the internet. Perhaps adjusting/ adding to the old forum (speaking of all forums- not this one in particular) ways would attract some new members. Does this...

The attitude that film photography is a fad with zeroing in on the younger generation and how it is anecdotally naive drives away the new members of the community. A top priority of this forum should...

Smart approach. I've been admiring Frederick Evans' work. Thank you.

It’s freezing cold outside, I just got into large format and I’m addicted, and I want to practice. This is a hobby and will always be (meaning I have no interest in selling anything.) Usually I can...

Ok. Nevermind, please remove this thread.

edit: If the users here do not know of a place, why feel the need to respond?

226026

What are some universal indoor public places that will allow practice photography with tripod.

I’ve been trying to decide on a wide fl too. I had a 90 (returned it because shutter was bad) and was surprised at how much it could see with rise. I’ve been debating about 75, but I think the 90...

Removed

Thanks. I believe I can see a rough little bit at the last thread. I’m discovering a lot of problems with my favorite online used retailer. I’ll have to search out a machinist. 225991

So it not picky if it could be tightened another turn or two, as long as it doesn’t unscrew?

Edit: because it spins on fine for many turns. Then it has resistance, but I can still turn it more. I...

Thanks- visual aid helps.

Mr Fromm, so it should tighten until it stops firmly- that’s what makes sense. Thank you.

Sorry- to be more clear: the shutter is mounted well. The rear element is where the question lies.

I’m new to this and was confused by for example fujis sw label meaning (I think) 105 degrees no matter the focal length. It makes sense they’re referring to image circle being 105 rather than fov....

I have a rodenstock 150 5.6. The rear element screws in fine until it reaches a point where there is resistance. I could keep tightening it, but it feels “wrong”. When do I stop tightening so it’s to...

Just in case it’s needed: https://web.archive.org/web/20061230032013/http://www.satinsnowglass.com/grids.pdf

Removed

Removed

Removed

225763
Here’s some guy who used a big one.

225757
Sinar F1 / Rodenstock 150 5.6 / Catalabs 80 / D-76 / Ilford Fiber Glossy

Hello. I have an F1 and one of my locking levers just broke. I designed, printed, and tested the lever and It works. I'm limited to PLA right now so that's what I used, but ABS is probably better....