Jay,
Did you check with CatLabs? From what I hear, they can get something like this.
Cheers,
Jim
Type: Posts; User: jkorpi; Keyword(s):
Jay,
Did you check with CatLabs? From what I hear, they can get something like this.
Cheers,
Jim
Duolab,
Yep. The right fuse. If I found that to be the issue at this point I would have surely walked into a river with stones in my pockets.
Good Old Norm.
This is hilarious and poignant. I was looking at the boards of this machine with a electrical genius the other day and he said to me, "You can hook power to just this and see if it...
Duolab, thanks for the encouragement and thoughts.
I just started really investigating the switch board itself. I've attached a schematic of the board. Basically I checked the resistors and...
Hey Mike.
So I brought power to the motor board independent of the switch board... and the motor ran just fine without blowing a fuse. So there must be a short coming from the switch boards. I'm not...
So I bypassed the other boards and powered up the motor board independent of the other two switch boards, and the motor spun just fine without blowing the fuse. So there must be some issue coming...
Mike,
The fuse blew when the motor was unplugged from the board.
I had unhooked the motor from the motor board and then powered up the unit. The fuse still blew without the motor hooked up, so...
Hey.
Great response. Thanks for your thoughts.
So, I have unhooked the motor from the motor board and then powered up the unit. The fuse still blew without the motor hooked up, so that tells me...
Hey Mike.
So I've put my transformer back in the unit after it seemed to test fine. I then hooked everything back up, except I unplugged the motor from the motor board before turning the power on to...
Mike,
Just curious, can I hard wire the transformer to a power cord and just plug it in to get a reading of the output? I'm just curious because the power coming out of my wall socket has a reading...
Mike,
Thanks a bunch for these thoughts. I'll try it today and let you know how it goes. I have tested the resistance on the primary and secondary and everything seems fine. Also there does not seem...
196533Hey all.
I've researched this problem thoroughly and tested just about everything including my patience and willpower. Basically I'm at the point where I think the DC transformer isn't...
Any thoughts on how I can figure out if my motor is in fact dead? The folks at Catlabs said it is VERY unlikely that the motor would go on this unit. Again, they said it would most likely be some...
Hello all.
I've tried searching the forum to find solutions to my problem, but my search turned up 164 pages of results, none of which I have found a solution.
I have a JOBO CPP2 processor. All...
I am curious if you found a solution to your motor problem. I am having the same issue with my Jobo CPP2. Everything works but the motor.
Curiously,
Jim