-
nega 138 help
i bought a Nega 138 for my durst 138. the plastic guides on the bottom side do not line up with the slots in the groves in the enlarger. they are almost set to wide by almost 1/2" Is there a way to adjust this? Is this the right carrier? thanks for any help
-
Re: nega 138 help
Post a photo of your dilemma to see if we can help.
-
3 Attachment(s)
Re: nega 138 help
Attachment 209867Attachment 209868Attachment 209869
Hopefully the photos loaded
The durst 138 I bought pretty much bare bones. It serial numbers is 612. That sounds early to me. I purchased a Nega 138 negative carrier. The distance between the groves on the enlarger is 10 1/4" the
The distance between the 2 white pins on the carrier is 10 11/16"
If I understand correctly, the white pins should slide in the groves.
when one pin is in the grove, the other one hangs over.
Thanks
-
Re: nega 138 help
That carrier has some kind of distinctly non-factory DIY conversion, adapted to some other application. You'll have to re-adapt the positioning.
-
1 Attachment(s)
Re: nega 138 help
Measured my Nega 138 as per the photo below. You may need to modify your Nega 138 to fit your enlarger. The metal pieces that hold the white pins on mine are riveted on. On yours it looks like they're bolted on so they may have been changed during its lifetime.
Attachment 209895
-
Re: nega 138 help
The 10 1/4 between the grooves is what my two 138"s measure. Maybe there is play in the bolt holes of your Nega 138 and you can move them inwards.
-
Re: nega 138 help
thanks for the input. I'll peal the felt back tomorrow, and see what is going on.