Printable View
Does anyone know what enlarger this lens board goes to? It looks like a Lapla on steroids and measures 4.5" diameter. On the third photo you can see a Lapla on the left and a Unipla on the right for comparison.
Thanks,
Luis
Attachment 144359Attachment 144360Attachment 144361
Durst enlarger?
Don't think it's a Durst, I showed this board between both the Durst Lapla and the Unipla which AFAIK are the only two Durst boards used on the Laborators. It's also not a De Vere or a Beseler or Chromemega F. I've had all those enlargers in the past (or present) so I'm familiar with their boards. L
Isn't a Durst PRODAP with a flange mounted onto. But supposed to be 130mm (5 1/8"). Is the part under the flange have a threat too?
If it is a Prodap, it's need the Prola adapter, same external size as Unipla but opening at 130mm.
Thought it might have been a PRODAP, but the size is wrong. The out side diameter at the bottom of the bevel is 110 cm or 4.5". The mouting flange is for a 240/300 Rodagon, so definately a LF enlarger. Come on Ginette, you're supposed to know everything! IC, any ideas? L
make that 110 mm, not cm!
Prodap is definitively 130mm, I have some but don't have the Prola.Quote:
Originally Posted by Luis-F-S
I don't know what it is, I know only Durst!!
Not FOTAR which are 5.75".
Maybe it was for custom made "printer". L