Jim Andrada
4-Jan-2013, 23:20
I've been using 3000 series tanks on my CPP2, but today I needed to run some 120 film in a 1520/30 tank
Even when attached to the lower gear on the lift the tank was not supported by the rollers on the lift arm. For a temporary measure I "shimmed" the end of the lift arm so the tank was level when resting in between the roller on the plastic base to which the small rollers are attached.
Is there a separate support/roller part for the smaller tanks? Would it slide onto the lift arms in place of the current unit? Is the crosspeice at the end of the lift arm removable to permit this?
Thanks much
Even when attached to the lower gear on the lift the tank was not supported by the rollers on the lift arm. For a temporary measure I "shimmed" the end of the lift arm so the tank was level when resting in between the roller on the plastic base to which the small rollers are attached.
Is there a separate support/roller part for the smaller tanks? Would it slide onto the lift arms in place of the current unit? Is the crosspeice at the end of the lift arm removable to permit this?
Thanks much