View Full Version : Tiny white spots on TMY in Tmax RS - any advice?
Phil Hudson
4-Jan-2013, 10:21
I'm developing TMY sheets and 120 rolls in a small tank with TMax RS developer and I'm getting very small white spots on the negative (ie tiny emulsion "pinholes") under a 10x lupe. It doesn't happen with TMX using the same method. Any ideas what might be causing it?
Thanks in advance!
Gem Singer
4-Jan-2013, 10:44
Acid stop bath?
Phil Hudson
4-Jan-2013, 11:12
Thanks Gem - I am using an acid stop bath. Would this make a difference?
JBelthoff
4-Jan-2013, 12:10
It depends on whether there is any carbonate in your developer. What happenes is when a developer contains sodium carbonate, used to increase the pH of the devloper, gets placed into an acid bath - carbon dioxide gas bubbles get released which can cause blistering in the emulsion. This would be a pin hole.
A plain water rinse to replace the acid stop bath should fix your problem assuming that is is a pin hole...
Phil Hudson
4-Jan-2013, 12:40
Thanks John - I'll give plain water a try.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.