View Full Version : foam brush? How to clean?
This is my first time to use a foam brush to coat a carbon tissue with Ammonium dichromate... How do I clean the brush afterword? should I just wash it with water?
Thank you in advance
Nasser
Erik Larsen
4-Aug-2012, 05:41
Yeah, just rinse it out with water and only use it for coating tissue so you don't contaminate anything else.
Regards
Erik
BrianShaw
4-Aug-2012, 09:40
I've thouroughly rinsed and re-used (as Erik said... using only for the same process) but for me they are so inexpensive and easy to get that I just throw them out.
Maybe you dont print much, I would go through tons of them, literally.
BrianShaw
4-Aug-2012, 11:28
That is very true, David. I don't print much so using one for a session and throwing away is not a problem for me. I wish I could print more, but...
Jay DeFehr
4-Aug-2012, 12:30
Maybe you dont print much, I would go through tons of them, literally.
Literally? I sincerely doubt that.
Erik Larsen
4-Aug-2012, 12:42
I've used the same one for years:)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.