rich caramadre
13-May-2012, 10:20
I'm going to process my first negs in 510 pyro in BTZS tubes. Delta 100 - 8x10. I have a few questions.
1. Should I presoak?
2. Should I use distilled water?
3. Do I use a stop bath of water bath?
4. Is Ilford Hypam fix OK?
5. I'm was going to start with the time for D76 stock as a starting time. But I will be printing on VC paper so should I go a bit longer?
Any suggestions are welcome.
Rich
1. Should I presoak?
2. Should I use distilled water?
3. Do I use a stop bath of water bath?
4. Is Ilford Hypam fix OK?
5. I'm was going to start with the time for D76 stock as a starting time. But I will be printing on VC paper so should I go a bit longer?
Any suggestions are welcome.
Rich