View Full Version : unicolor print drum use question
rich caramadre
8-May-2012, 06:58
If you use a print drum and a roller base to process sheet film, how do you keep the developer temp. consistent ?
Jim Noel
8-May-2012, 08:46
Temperature control when processing in a tube has never been a problem for me. The plastic from which the tubes are made does not transfer heat very effectively therefore the temperature of the solutions vary very little if at all.
jcoldslabs
8-May-2012, 16:18
Ditto, but I am less of a stickler for temperature consistency than most.
Jonathan
Unless the room temperature is at a extreme to 20degC there is not much change over the development time
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.